Basic Settings - Bosch GLM 500 Professional Original Instructions Manual

OBJ_BUCH-3009-001.book Page 23 Thursday, October 13, 2016 11:47 AM
Selecting the Reference Level
(see figure A)
For the measurement, you can select between three
different reference planes:
– the rear measuring-tool edge (e.g. when measur-
ing onward from a wall),
– the front measuring-tool edge (e.g. when measur-
ing onward from a table edge),
– the centre of thread 13 (e.g. for tripod measure-
ments).
To select the reference level, press button 4. Use but-
ton 3 [+] or button 8 [–] or button 4 to select the de-
sired reference level. The rear edge of the measuring
tool is pre-set as the reference level every time the
measuring tool is switched on.

"Basic Settings"

To enter the "basic configurations" menu (h) press
and hold the button 7 [Func].
Select the respective basic configuration and your
setting.
To exit the "basic configurations" menu, press the
On/Off button 5 [
Bosch Power Tools
English | 23
] again.
1 609 92A 3F7 | (13.10.16)