HP FlexFabric 5940 Configuration Manual page 10

Step
1. Enter system view.
2. Configure a static
route for a VPN
instance.
3. (Optional.) Configure
the default preference
for static routes.
Configuring RIP between an MCE and a VPN site
A RIP process belongs to the public network or a single VPN instance. If you create a RIP process
without binding it to a VPN instance, the process belongs to the public network. Binding RIP
processes to VPN instances can isolate routes of different VPNs. For more information about RIP,
see Layer 3—IP Routing Configuration Guide.
To configure RIP between an MCE and a VPN site:
Step
1. Enter system view.
2. Create a RIP process for a
VPN instance and enter RIP
view.
3. Enable RIP on the interface
attached to the specified
network.
4. Redistribute remote site
routes advertised by the PE
into RIP.
Configuring OSPF between an MCE and a VPN site
An OSPF process belongs to the public network or a single VPN instance. If you create an OSPF
process without binding it to a VPN instance, the process belongs to the public network.
Binding OSPF processes to VPN instances can isolate routes of different VPNs. For more
information about OSPF, see Layer 3—IP Routing Configuration Guide.
To configure OSPF between an MCE and a VPN site:
Step
1. Enter system view.
2. Create an OSPF process for
a VPN instance and enter
OSPF view.
Command
system-view
ip route-static vpn-instance s-vpn-instance-name
dest-address { mask-length | mask } { interface-type
interface-number [ next-hop-address ] |
next-hop-address [ public ] [ track
track-entry-number ] | vpn-instance
d-vpn-instance-name next-hop-address [ track
track-entry-number ] } [ permanent ] [ preference
preference ] [ tag tag-value ] [ description text ]
ip route-static default-preference
default-preference
Command
system-view
rip [ process-id ] vpn-instance
vpn-instance-name
network network-address
import-route protocol
[ process-id | all-processes |
allow-ibgp ] [ allow-direct | cost
cost-value | route-policy
route-policy-name | tag tag ] *
Command
system-view
ospf [ process-id | router-id
router-id | vpn-instance
vpn-instance-name ] *
7
Remarks
N/A
By default, no static
routes are configured.
Perform this
configuration on the
MCE. On the VPN
site, configure a
common static route.
The default
preference is 60.
Remarks
N/A
Perform this configuration on the
MCE. On a VPN site, create a
common RIP process.
By default, RIP is disabled on an
interface.
By default, no route is
redistributed into RIP.
Remarks
N/A
Perform this configuration on the
MCE. On a VPN site, create a
common OSPF process.
An OSPF process bound to a VPN
instance does not use the public
network router ID configured in
system view. Therefore, configure