Changing Battery - McKesson TRUE METRIX PRO Instruction Manual

Changing Battery

A low battery displays Battery Symbol while
continuing to function. A dead battery
displays Battery Symbol, beeps, and then
turns off. To replace battery:
1. Lift tab on Battery Door.
2. Turn meter over. While holding
meter in one hand with Battery
Door facing down, tap meter
gently on the palm of your other
hand to loosen and remove battery.
3. Discard old battery into
appropriate container.
4. Insert new battery, positive ("+")
side facing up. Close Battery Door.
Note: Use non-rechargeable 3V lithium battery (#CR2032).
5. Press " • " Button to turn meter on and check time,
date, and Testing Alerts and Reminders (see
Meter Set Up). If meter does not turn on, check that
battery was installed properly. If not, remove and
reinsert battery and turn meter on by pressing " • "
Button. Call for assistance if problem persists.
Caution!
Batteries might explode if mishandled or incorrectly
replaced. Do not dispose of battery in fire. Do not
take apart or attempt to recharge battery. Dispose
according to local regulations.
39
Low
Tab
Battery
Door