Battery Replacement - McKesson TRUEresult Owner's Manual

TRUEresult Quality Assurance / Quality Control Manual
®

Battery Replacement

The Low Battery Symbol displays if the battery needs to be changed. The Meter
will continue to function for about 50 more tests before Meter will not test. A
dead battery displays the Battery Symbol, beeps, and then turns off. Use only a
new 3V non-rechargeable lithium battery (#CR2032)
1. Lift Section on Battery Door.
2. Turn Meter over, tap gently on the palm of your other hand to loosen and
remove battery.
3. Replace battery with a new non-rechargeable lithium battery (#CR2032),
positive ("+") side facing up. Close Battery Door.
4. Discard the old battery in an appropriate container.
5. Press the "S" Button to turn the Meter on. If Meter will not turn on, check
that the battery was installed properly with "+" facing up. If not, remove and
reinsert battery and try again. Call for assistance if problem persists.
Caution! Batteries may explode if mishandled or incorrectly replaced. Do not
dispose of battery in fire. Do not take apart or attempt to recharge
battery. Dispose according to local/country regulations.
Note: If battery dies or is replaced, the Ketone Alert and the Testing Reminders
may have to be reset. See Set Up of Time, Date, Ketone Alert, Testing
Reminders, Section 5 for more information.
Low
Tab
Battery
Door
41