Safety; Export - ergoline Lounge Turbo Power Operating Instructions Manual

Please read and observe ...

Safety

Danger!
Assembly and electrical connection must comply with the
1)
national regulations.
Assembly, installation, upgrading or repair of the device
may only be carried out by specially trained and instructed
personnel.
• All danger and safety notes attached to the device must be observed!
• No safety equipment (e.g. panel switch) or safety notes may be
removed or deactivated which can impair the safe operation of the
device!
• The device may only be operated in proper condition!
• The device operating time must be controlled with a timing device in
accordance with the standards EN 60335-2-27 and A1 2000 Section
22.108 and 22.109. This timing device must be designed so that the
device is automatically switched off at the latest after <110% of the
selected operating time even when the controller fails.
• Do not change, obstruct or block the air inflow and outflow area to the
device or make any unauthorised changes to the device – see Page
56. The manufacturer shall bear no liability for damage or injuries
resulting from such actions.
1) In Germany: VDE regulations
Caution!
The code for access via the infrared interface is preset in
the software of the hand-held unit, and can therefore be
used with any unit. Anyone, who downloads the software
from the Internet can access the unit date with a hand-held
unit. Please note that Customer Service changes the preset
access code during initial start-up – see Page 79. Please
note the new code for future use!
This code is independent of the access code for the preset-
tings via the control panel.

Export

We emphasise that these devices are intended for the European market
and must not be exported to nor operated in the USA or Canada!
The manufacturer shall assume no liability whatsoever in case of non-
observance! We explicitly emphasise that high liability risks may occur
for the exporter an/or the operator in case of non-observance.
33