On Timer Operation - Daikin K-Series Service Manual

SiBE061121.book Page 61 Friday, April 22, 2011 4:12 PM
SiBE061121

2.11 ON TIMER Operation

ON TIMER Operation

NOTE
In the following cases, set the timer again.
• After a breaker has turned off.
• After a power failure.
• After replacing batteries in the remote controller.
Operation Manual
To use ON TIMER operation
• Check that the clock is correct.
If not, set the clock to the present time.
1.
Press .
" • " is displayed on the LCD.
" • " blinks.
" • " and day of the week disappear from the LCD.
2.
Press until the time setting reaches the
point you like.
• Each pressing of either button increases or decreases the time setting by 10 minutes.
Holding down either button changes the time setting rapidly.
3.
Press again.
" • " and setting time are displayed on the LCD.
• The OPERATION lamp blinks and the TIMER lamp lights yellow.
Display
To cancel ON TIMER operation
Press .
" • " and setting time disappear from the LCD.
" • " and day of the week are displayed on the LCD.
To combine ON TIMER and OFF TIMER
• A sample setting for combining the 2 timers is shown below.
(Example)
Present time: 23:00 (The unit operating)
OFF TIMER at 0:00
Combined
ON TIMER at 14:00
Operation Manual
Page 10
Page 5
20
61