Table of Contents
Advertisement
Safety Instructions
Read the Safety Instructions carefully and keep it for use later.
The chassis metalwork of the module must be installed properly to the
main earthing termination for Class 1 equipment.
Care must be exercised in the application of the system to prevent
overheating. Ensure that the ambient temperature around the system
does not exceed 60°C and provide adequate means of ventilation to
achieve this.
When cleaning cut off the electrical supply at all times. Never use liquid or
aerosol detergent, use a soft damp cloth instead.
Never insert anything metallic into the enclosure opening. This may create
an electric shock hazard or hazard from rotating fan blades.
To avoid electric shock, never touch the inside of the system. There are
no user adjustable components inside, only a qualified technician should
open the system's case.
Fins on the rear system enclosure are to allow for cooling. To prevent
overheating, these fins should not be blocked or covered.
If the system does not operate normally – in particular, if there are any
unusual sounds or smells coming from it – disconnect it immediately.
Do not put pressure on the LCD panel screen because it is very fragile.
Always handle the system with care when moving it.
Take care that the system is disposed of correctly at the end of its life. If in
doubt refer to your local ordinances or regulations for proper disposal.
A socket-outlet shall be installed near the equipment and shall be easily
accessible.
Cleaning the LCD monitor
To clean the LCD panel:
Wipe the screen gently with a clean lens brush made of camel hair, or a
soft, clean, lint free cloth. This is to remove dust and other particles
without scratching the LCD panel.
If it is still not clean, then wipe with a damp lint free cloth and blow on it to
dry.
Desirable cleaners are water, IPA (Isopropyl Alcohol) or Hexane.
19.0" Enclosed VESA Mount PC User's Guide
Page 3
Advertisement
Table of Contents
