Master Spas INT MP FORCE Owner's Manual page 86

Deluxe Fusion BT Stereo Option –
Getting started
2.1 REMOTE CONTROL BATTERY INSTALL
Remove the RF wireless remote control from the Digital Media Locker box. Unscrew the waterproof
cap on the back of the remote control. Place the CR-2450 battery in the RF remote control and
replace the water/dust proof cap.
When the battery is installed, the remote control LCD should be solid and bright without any flick-
ering.
2.2 POWER ON
Press the on/off button.
Red Light: Power to the docking station is ON, but the unit is in standby mode.
Blue Light: The unit is powered ON and looking for an audio source.
For applications that require low current draw and where battery drain may occur, the power but-
ton must be turned OFF inside the unit. When the power button is in the OFF position the red LED
will not be lit.
For applications where a 12V battery is not used, such as in a swim spa, the power button can be
left ON and the remote control or door controls can then be used to power on/off accordingly.
2.3 REMOTE CONTROL SYNCHRONIZING
1. Turn the Digital Media Locker to off mode with the power button inside the door. The LED
should not be illuminated.
2. Press the red
3. Press and hold the
4. Continue to press and hold the
5. Turn the docking station to standby mode (within 10 seconds) with the on/off button inside
door (the red LED will illuminate and then turn blue).
6. The remote's LCD should read WELCOME or show a mode position such as RADIO, USB, BT or
AUX IN.
For any additional remote controls, you will also need to activate/synchronize those remote controls
by following the steps above.
If the pairing process is not effective, switch the locker off using the on/off button located
inside the door of the dock. Unplug the 12-pin Harness on the back of the Locker for 3 min-
utes. Reattach the Harness and repeat steps 1-6 above.
If the pairing process is not effective, check the battery voltage. If above 3V DC refer to sec-
tion 1.5 above top make sure the battery is installed correctly. If battery voltage is below 3V
DC replace the battery.
If the LCD displays "NO LINK" in either mode, this means the remote is out of reception range.
Move the remote closer to the Locker and try again.
If you lose your remote control and buy another new remote control, please follow the above
to start pairing before normal usage.
DO NOT DIVE. DO NOT DIVE.
(POWER) button on the remote.
(MODE) button until the LCD reads PAIR.
(MODE) button during step 5 below.
104 84