Verifying The Configuration - HPE FlexNetwork MSR Series Comware 5 Security Configuration Manual

[Sysname-luser-test] authorization-attribute level 3
[Sysname-luser-test] password
Password:***********
Confirm :***********
Updating user(s) information, please wait...........
[Sysname-luser-test] quit
# Save the configuration.
[Sysname] save
The current configuration will be written to the device. Are you sure? [Y/N]:y
Please input the file name(*.cfg)[cfa0:/startup.cfg]
(To leave the existing filename unchanged, press the enter key):
cfa0:/startup.cfg exists, overwrite? [Y/N]:y
Validating file. Please wait....
The current configuration is saved to the active main board successfully.
Configuration is saved to device successfully.
[Sysname] quit
# Reboot the device.
<Sysname> reboot

Verifying the configuration

After the device reboots, enter username test and password AAbbcc1234%. The system prompts
you to configure a new password. After the new password is set, the host logs in to the device. The
new password must have at least four characters different from the old password.
User interface con0 is available.
Please press ENTER.
Login authentication
Username:test
Password:
Info: First logged in. For security reasons you will need to change your password.
Please enter your new password.
Password:**********
Confirm :**********
Updating user(s) information, please wait...........
<Sysname>
# Display the current FIPS mode state.
<Sysname> display fips status
FIPS mode is enabled
486