HPE FlexNetwork MSR Series Comware 5 Security Configuration Manual page 390

It will take a few minutes.
Press CTRL+C to abort.
Input the bits of the modulus[default = 1024]:
Generating Keys...
++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
+++++++++++++++++++++++++++++++++++
# Enable the SSH server function.
[Router] ssh server enable
# Enable the SFTP server.
[Router] sftp server enable
# Configure an IP address for interface Ethernet 1/1. The client uses this address as the
destination for SSH connection.
[Router] interface ethernet 1/1
[Router-Ethernet1/1] ip address 192.168.1.45 255.255.255.0
[Router-Ethernet1/1] quit
# Set the authentication mode of the user interfaces to AAA.
[Router] user-interface vty 0 4
[Router-ui-vty0-4] authentication-mode scheme
# Enable the user interfaces to support SSH.
[Router-ui-vty0-4] protocol inbound ssh
[Router-ui-vty0-4] quit
# Configure a local user named client002 with the password aabbcc and the service type ssh.
[Router] local-user client002
[Router-luser-client002] password simple aabbcc
[Router-luser-client002] service-type ssh
[Router-luser-client002] quit
# Configure an SSH user client002 with authentication method password and service type
SFTP.
[Router] ssh user client002 service-type sftp authentication-type password
2. Establish a connection to the SFTP server:
The device supports different types of SFTP client software. The following uses PSFTP of
PuTTY version 0.58 as an example.
PSFTP supports only password authentication.
To establish a connection to the SFTP server:
a. Run the psftp.exe to launch the client interface as shown in
following command:
open 192.168.1.45
b. Enter username client002 and password aabbcc as prompted to log in to the SFTP server.
377
Figure 128, and enter the