TP-Link EAP110 User Manual page 37

· External Radius Server
If you have a RADIUS server on the network to authenticate the clients, you can select
External Radius Server. Clients need to provide the correct login information to pass the
authentication.
Follow the steps below to configure External Radius Server as the portal authentication
type:
1. Build a Radius server on the network and make sure that it is reachable by the EAP.
2. Go to the Portal configuration page on the EAP. Select External Radius Server as the
authentication type.
3. Configure the relevant parameters as the following table shows:
RADIUS Server IP
Port
RADIUS
Password
Enter the IP address of RADIUS server.
Enter the port of the RADIUS server.
Enter the password of the RADIUS server.
33