TP-Link EAP110 Quick Installation Manual

Quick Installation Guide
EAP110
7106505541 REV1.0.0 7106505541 REV1.0.0
2
Hardware Overview
LED Indication
Solid green
The device is working properly.
Flashing red
System errors. RAM, Flash,
Ethernet, WLAN or firmware
may be malfunctioning.
4
Power Supply
The EAP110 can be powered with the provided PoE adapter.
3
PoE Adapter
PoE LAN
1
(Up to 100m)
1. Connect the ETHERNET port to the POE port of the PoE adapter using an Ethernet cable. The cable
length can be up to 100 meters.
2. Connect the Ethernet cable from the switch to the LAN port of the PoE adapter.
3. Plug the female connector of the provided power cord into the PoE adapter, and the male connector to a
power outlet.
1
Network Topology Requirement
EAP Controller
Controller Host
A DHCP server (typically a router) is required to assign IP addresses to the EAP and clients in your local network.
A computer running the EAP Controller software, which can be in the same or different subnet with the EAPs.
Interface Panel
Flashing yellow RESET
Firmware update is in progress. With the device powered on, press and hold the button for about 8 seconds until the LED flashes red, then
Do not disconnect or power off release the button. The device will restore to factory default settings.
the device.
Double-flashing red, green, yellow ETHERNET
The port is to connect to the POE port of the provided PoE adapter for both data transmission and power
The device is being reset to its
supply through Ethernet cabling.
factory default settings.
Passive PoE Adapter
Switch
2
Power LED
The Power LED indicates the status of the electric current: green (0-0.8A), red (0.8A-1A).
PoE Port
This port is used to connect to the
ETHERNET port of EAP110.
Internet
Router
RESET ETHERNET
Power LED
LAN Port
This Port is used to connect to your LAN.
EAP
Switch
EAP
EAP
3
Hardware Installation
The EAP can be ceiling rail mounted, ceiling-mounted, and wall-mounted.
The instructions for various mounting options are on the back of this Quick Installation Guide.
Option 1: Ceiling Rail Mounting
Option 2: Ceiling Mounting
Option 3: Wall Mounting
5
Software Configuration
To quickly set up a wireless network connection with mass EAPs, please follow the steps below.
Note: The IP address of the management computer must be reachable for the EAPs in the network.
Step 1: Installing the EAP Controller
Find the EAP Controller application file on the Resource CD (for Windows user only) or from our website at
www.tp-link.com. Run the file and follow the wizard to install the EAP Controller on the computer.
Step 2: Configuring the EAP Controller
Launch the EAP Controller and follow the configuration wizard to create a primary wireless network. After the wizard
is finished, a login screen will appear. Enter the admin name and password you created and click Sign In.
Step 3: Adopting the EAP devices
Adopt the EAP devices in the Controller management interface to change the status from pending to connected.
For More Configurations
Now you can manage your wireless network and view network statistic using the EAP Controller. Please refer
to the EAP Controller User Guide to learn more information on configuring and using the Controller software.
Clients