Calspas patio plus Owner's Manual page 22

20
Setting the Heat Mode
Press
Then
Press
Toggle between
READY and REST
Ready-in-Rest Mode
READY/REST appears in the display if the spa is in Rest Mode and Jet 1
is pressed. When the spa is being used, it will heat to set temperature.
While Pump 1 High can be turned on and off, Pump 1 Low will run until
set temperature is reached, or 1 hour has passed. After 1 hour, the system
will revert to Rest Mode. This mode can also be reset by entering the Mode
Menu and changing the Mode.
Setting Time
Press
Then
Press
Flip (Invert Display)
Press
Then
Press
www.calspas.com
There are two heat modes: READY Mode and REST Mode.
Once
READY Mode: In order for the spa to heat, a pump needs to circulate water
through the heater. The pump that performs this function is known as the
"heater pump."
Twice
The heater pump can be either a 2-Speed Pump 1 or a circulation pump. If the
heater pump is a 2-Speed Pump 1, READY Mode will circulate water every 1/2
hour, using Pump 1 Low, in order to maintain a constant water temperature,
Main Screen
Setting the time of day is important for determining filtration times and other
background features. 24-hour time display can be set under the PREF menu.
Once
Note: This system does NOT display the time of day . The default
3x
display on the Main Screen is the current water temperature .
Displaying time of day is not a selectable feature .
Set hour
Once
Inverting the display allows you to be able to read the control panel while you
are in the spa.
4x
Press Temp button to
flip the display
heat as needed, and refresh the temperature display.
This is known as "polling."
REST Mode: REST Mode will only allow heating
during programmed filter cycles. Since polling does not
occur, the temperature display may not show a current
temperature until the heater pump has been running
for a minute or two.
Press Jets 1
Set minutes
Main Screen
Main Screen
Main Screen
2017 Portable Spa
LTR20171001, Rev. C