Calspas patio plus Owner's Manual page 16

14
5 . Prime the pump .
After two minutes, the pump should prime. If it does not, follow the priming instructions on the next page. If it
does, continue with the next step.
6 . Install the filter into the filter canister.
Make sure the filter has soaked at least 30
minutes before you install it.
www.calspas.com
Your spa will perform a self-diagnostic check and go into
Priming Mode. The control panel will display either RUN
PUMPS PURG AIR --- or Priming Mode, depending on
which control panel you have.
Do the following:
Press the JETS or JETS 1 button once to start the pump in
low speed.
a. Press it again to switch the pump to high speed.
b. If you have other pumps, press JETS 2 or JETS 3
to turn them on also. Running the pumps helps the
pumps prime.
7 . Adjust water chemistry .
Test and adjust the water chemistry. See the section
on page 40. for instructions on keeping your water
clear.
Spa owners with the bromine generator need to
follow the instructions on page 38.
8 . Let the spa heat up .
When the spa has finished priming, the heater will
activate. Put the cover on and let the spa heat to the
set temperature.
2017 Portable Spa
LTR20171001, Rev. C