Headset Operation - VTech VT1923 Manual

HEADSET OPERATION

Your Vtech cordless phone is equipped
with a 2.5mm Headset Jack for use
with an optional accessory Headset for
hands-free operation.
If you choose to use the Headset
option, you must obtain an optional
a c c e s s o r y H e a d s e t , w h i c h i s
compatible with the Vtech cordless
phone.
To purchase a Headset, call Vtech at
1-800-595-9511.
Once you have a compatible 2.5mm
Headset, locate the Headset Jack on
the Vtech cordless phone Handset.
Connect the plug on the Headset cord
to the jack on the cordless Handset.
The plug should fit securely. Do not
force the connection
OPERATION
NOTE:
Whenever a compatible Headset is
connected to the cordless Handset,
the microphone on the Handset will
be muted. This is done to limit the
effect of background noise.
T h e f o l l o w i n g
characteristics apply to Vtech
Headsets. The same may also apply
to other, non-Vtech supplied Headsets,
but Vtech assumes no responsibility
for their performance.
The Vtech compatible Headset has a
reversible, monaural design. You can
wear your Headset on either ear,
leaving one ear free for room
conversation.
The headband can be adjusted to fit
the contour of you head. Using both
hands, slide the headband up or down
o p e r a t i o n a l
22
so that it rests comfortably on your
head, with the speaker cushion
centered against your ear.
For maximum sound quality, the flexible
microphone should be positioned at
the corner of your mouth, about one
inch from your face.
BELT CLIP
The Vtech cordless phone is also
equipped with a detachable belt clip.
Align the pins on the inside edge of the
clip with the notches on the sides of
the Vtech cordless phone Handset.
The belt clip should snap securely into
place. Do not force the connection.