Replacing The Camera Module - Lenovo ideacentre All-In-One Y910 Hardware Maintenance Manual

Step 16. Lift up the speaker to remover it.
Step 17. To install the new speaker system:
a. Align the new speaker into position.
b. Align the hole in hinge cover with the one on the chassis and secure the hinge cover to the
chassis with one screw.
Step 18. Reattach the EMI cover, system fan, rear I/O module, stand holder, middle cover, optical drive,
hard disk drive, graphic card, rear covers and stand base.

Replacing the camera module

Note: Turn off the computer and wait 3 to 5 minutes to let it cool down before removing the cover.
Note: It may be helpful to place the computer face-down on a soft flat surface for this procedure. Lenovo
recommends that you use a blanket, towel, or other soft cloth to protect the computer screen from scratches
or other damage.
To replace the camera module:
Step 1. Remove any media from the drives, shut down the operating system, and turn off the computer
and all attached devices.
Step 2. Unplug all power cords from electrical outlets.
Step 3. Disconnect all cables attached to the computer. This includes power cords, input/output (I/O)
cables, and any other cables that are connected to the computer. Refer to Locating connectors,
controls and components to locate the various connectors.
Step 4. Remove the stand base. Refer to Removing the stand base.
Step 5. Remove the rear cover. Refer to Removing the rear covers.
Step 6. Remove the graphic card. Refer to Replacing the graphic card.
52
ideacentre All-In-One Y910 Computer Hardware Maintenance Manual