Removing The Stand Holder - Lenovo ideacentre All-In-One Y910 Hardware Maintenance Manual

Step 9. Remove the three screws that secure the system fan to the EMI cover.
Step 10. Disconnect the system fan power cable from the connector on the motherboard.
Step 11. Lift up the system fan to remove it from the EMI cover.
Step 12. To install the new system fan:
a. Connect the system fan power cable to the connector on the motherboard.
b. Place the new system fan into position, and then secure it to the EMI cover with three screws.
Step 13. Reattach the middle cover, optical drive, hard disk drive, graphic card, rear covers and stand base.

Removing the stand holder

Attention: Turn off the computer and wait 3 to 5 minutes to let it cool down before removing the cover.
Note: It may be helpful to place the computer face-down on a soft flat surface for this procedure. Lenovo
recommends that you use a blanket, towel, or other soft cloth to protect the touch screen from scratches
or other damage.
Step 1. Remove any media from the drives, shut down the operating system, and turn off the computer
and all attached devices.
Step 2. Unplug all power cords from electrical outlets.
Step 3. Disconnect all cables attached to the computer. This includes power cords, input/output (I/O)
cables, and any other cables that are connected to the computer. Refer to Locating connectors,
controls and components to locate the various connectors.
Step 4. Remove the stand base. Refer to Removing the stand base.
Step 5. Remove the left and right rear covers. Refer to Removing the rear covers.
Step 6. Remove the graphic card. Refer to Replacing the graphic card.
Step 7. Remove the hard disk drive. Refer to Replacing the hard disk drive.
44
ideacentre All-In-One Y910 Computer Hardware Maintenance Manual