Table of Contents
Advertisement
Limitless™ Series WLS Limit Switch
1.8
Symbol Definitions
The following table lists those symbols used in this document to denote certain conditions.
Table 3 – Table Symbol Definitions
Symbol
,
CAUTION
m
m
m
m
6
Honeywell Sensing and Control
Definition
ATTENTION: Identifies information that requires special consideration.
TIP: Identifies advice or hints for the user, often in terms of performing a task.
Indicates a situation which, if not avoided, may result in equipment or work (data) on the system
being damaged or lost, or may result in the inability to properly operate the process.
CAUTION: Indicates a potentially hazardous situation which, if not avoided, may result in minor
or moderate injury. It may also be used to alert against unsafe practices.
CAUTION symbol on the equipment refers the user to the product manual for additional infor-
mation. The symbol appears next to required information in the manual.
WARNING: Indicates a potentially hazardous situation, which, if not avoided, could result in
serious injury or death.
WARNING symbol on the equipment refers the user to the product manual for additional infor-
mation. The symbol appears next to required information in the manual.
WARNING, Risk of electrical shock: Potential shock hazard where HAZARDOUS LIVE volt-
ages greater than 30 Vrms, 42.4 Vpeak, or 60 Vdc may be accessible.
ESD HAZARD: Danger of an electro-static discharge to which equipment may be sensitive.
Observe precautions for handling electrostatic sensitive devices.
Protective Earth (PE) terminal: Provided for connection of the protective earth (green or green/
yellow) supply system conductor.
Functional earth terminal: Used for non-safety purposes such as noise immunity improve-
ment. NOTE: This connection shall be bonded to Protective Earth at the source of supply in
accordance with national local electrical code requirements.
Earth Ground: Functional earth connection. NOTE: This connection shall be bonded to Protec-
tive Earth at the source of supply in accordance with national and local electrical code require-
ments.
Chassis Ground: Identifies a connection to the chassis or frame of the equipment shall be
bonded to Protective Earth at the source of supply in accordance with national and local electri-
cal code requirements.
C-Tick Mark. The C-Tick Mark is a certification trade mark registered to ACMA (Australian Com-
munications and Media Authority) in Australia under the Trade Marks Act 1995 and to RSM in
New Zealand under section 47 of the NZ Trade Marks Act. The mark is only to be used in accor-
dance with conditions laid down by ACMA and RSM. This mark is equal to the CE Mark used in
the European Union.
Notified Body. For radio equipment used in the European Union in accordance with the R&TTE
Directive, the CE Mark and the notified body (NB) identification number is used when the NB is
involved in the conformity assessment procedure. The alert sign must be used when a restric-
tion on use (output power limit by a country at certain frequencies) applies to the equipment
and must follow the CE marking.
50054911
ISSUE 3
Advertisement
Table of Contents
