Emc Specifications; Functional Specifications; Environmental Specifications; Agency Compliance Information - Honeywell 50054911 Installation Manual

Limitless series wls limit switch
Table of Contents

Advertisement

Limitless™ Series WLS Limit Switch
2.5

EMC Specifications

The latest applicable EMC Standards are as follows:
EN 300 328, V1.7.1
EN 61326-1 (2006)
EN 301 489-1, V1.8.1
EN 301 489-17, V2.1.1
2.6

Functional Specifications

Table 11 – WLS Mechanical/Magnetic Actuator Cycle Testing with WDRR Monitoring (99.9 % count detection)
Item
High temperature endurance
Low temperature endurance
Electrical operation (normal speed)
Electrical operation (low speed)
2.7

Environmental Specifications

Table 12 – Environmental Specifications
Item
Operating temperature
Storage temperature
Operating humidity
2.8

Agency Compliance Information

2.8.1 FCC Compliance Statements

This device complies with Part 15 of FCC Rules and Regulations. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference and (2) this device must accept any interference received, including interference
that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installa-
tion. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with these instructions, may cause harmful interference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user will be required to correct the interference at his/her own
expense.
Intentional or unintentional changes or modifications must not be made to the WLS unless under the express consent of the
party responsible for compliance. Any such modifications could void the user's authority to operate the equipment and will
void the manufacturer's warranty.
Specification
85 °C, 10,000 cycles, 15 cpm
40 °C, 10,000 cycles, 15 cpm
25°C, 40,000 cycles, 15 cpm
25°C, 48 cycles, 1 cycle per hour
Specification
-40 °C to 85 °C [-40 °F to 185 °F] (operating head code K: -29 °C to 85 °C [-20 °F to 185 °F]
-40 °C to 85 °C [-40 °F to 185 °F]
0 %RH to 100 %RH
50054911
ISSUE 3
Honeywell Sensing and Control
9

Advertisement

Table of Contents
loading

Table of Contents