Advertisement
Quick Links
5869
HOLD-UP SWITCH/TRANSMITTER
The 5869 Hold-Up Switch/Transmitter is a finger-operated
RF transmitting device. It is typically mounted under a
counter or money draw for inconspicuous operation.
When the transmitter is activated, it emits an RF signal to
the receiver. The security system control panel sends a
burglary alarm to the central station when a RF signal is
received from an enrolled Hold-Up Switch/Transmitter.
FEATURES
• No wires to run
• Front and back tamper resistant
SPECIFICATIONS
Physical
• 1-15/16" W x 5-15/16" H x 1 3/16"D
(50mm x 150mm x 30mm)
Frequency
• 345 MHz
Battery
• 3V Lithium ADEMCO 466
or equivalent
Once activated, the 5869 Hold-Up Switch/Transmitter can
only be reset by the reset key. The 5869 also incorporates
tamper switches that are activated when the cover is
removed, or if the unit is forcibly removed from its
installation location.
• Easily mounted
• Quick enrollment
Agency Listings
• UL listed for Household Burg UL
1023,Hold-up Burg UL 636 and
CUL 634
• For certified UL commercial
installations, use with 5881ENHC
tamper-protected wireless receiver
• Includes battery
Compatibility
• Fully compatible with all
VISTA Control Panels
Advertisement
Related Manuals for Honeywell 5869
Summary of Contents for Honeywell 5869
- Page 1 Once activated, the 5869 Hold-Up Switch/Transmitter can RF transmitting device. It is typically mounted under a only be reset by the reset key. The 5869 also incorporates counter or money draw for inconspicuous operation. tamper switches that are activated when the cover is...
- Page 2 “RF” (i.e., supervised RF) Type System Control Panel Installation and Setup Guide for programming 2. Observing correct polarity, insert the • The 5869 is one closed input loop battery into the battery holder. instructions. zone (loop 1) NOTE: Use care not to bend the antenna while attempting to install battery.