Advertisement
MSM750 Controller Quickstart
C. Start the MSM750
Power on the MSM750 and wait until the power light stops blinking.
D. Connect to the management tool and log in
A factory-default MSM750 is assumed.
Note:
1.
In a web browser, enter the address: https://192.168.1.1.
2.
At the security certificate prompt proceed as follows:
•
In Microsoft Internet Explorer 7, select Continue to this website.
•
In Firefox 2, select Accept this certificate temporarily for this session and OK.
To eliminate the security warning, you need to replace the default certificate that is
installed on the MSM750. For more information, see About certificate warnings in the
MSM7xx Controllers Management and Configuration Guide.
3.
On the Login page, enter admin for Username and Password and then select Login.
4.
On the License Agreement page, read the agreement and select Accept License
Agreement.
5.
On the Registration page, register now if desired. You can register later by selecting
Service Controller >> Maintenance > Registration.
6.
If a Country prompt appears, select the country in which the MSM750 will operate.
The correct country must be selected.
Caution:
Using the management tool
In this quickstart and referenced documentation,
instructions to select specific management tool
elements and menus are specified in the form:
"Select Service Controller >> Security > Firewall."
This instructs you to select the Service Controller
element in the Network Tree, and then in the right
pane, select the Security main menu, and finally,
select its Firewall sub-menu. All elements to the left
of the double angle brackets >> are found in the
Network Tree.
3
7.
At the password prompt it is recommended that you change the password. Enter the
new password and select Save. Passwords must be at least six characters long and
include four different characters.
E. Configure system time settings
Accurate time is critical for correct operation of the MSM750, as the time configured on the
MSM750 is used on all controlled APs. Configure system time settings as follows:
1.
In the management tool, select Service Controller >> Management > System time.
Key elements of the management tool user interface are defined as follows:
HP ProCurve Networking
Advertisement
