Adjusting The Contrast; Setting The Pbx Number - Curtis TC970 Manual

Caller ID System Operation

Adjusting the Contrast

1. Press the PROG/MUTE button to enter the menu.
2. Press the {5 JKL} button to go to the contrast programming option.
3. Press the FLASH/EDIT button to change the setting. "2" will begin flashing.
4. Press the UP or DOWN button to toggle between three levels of contrast.
5. When the setting you desire is displayed, press the SAVE/MEM button to save the
setting. A double beep will sound to confirm the setting has been saved.
Continue with programming or press the PROG/MUTE button to return to the idle
6.
screen.

Setting the PBX Number

1.
Press the PROG/MUTE button to enter the menu.
2.
Press the {6 MNO} key to go to the PBX number programming option.
3. Press the FLASH/EDIT button to change the setting. "9" will begin flashing.
4.
Press the UP or DOWN button to customize the digit to match your PBX system.
5.
When the setting you desire is displayed, press the SAVE/MEM button to save the
setting. A double beep will sound to confirm the setting has been saved.
6.
Continue with programming or press the PROG/MUTE button to return to the idle
screen.
Note: The number you programmed is not active unless the PBX mode is On.
TC970 MAUNAL black.p65
18
18 02-5-22, 9:38