Quantum Scalar i40 Quick Start Manual page 24

Quantum Scalar Key Manager 2.5 Quick Start Guide
Figure 10 SKM Admin
Commands
24
Note: The default SKM VM server IP address is: 192.168.20.4.
14 When finished press <Enter>.
A message lets you know there are no certificates loaded on the SKM server.
15 Press <Enter>.
The list of SKM Admin commands displays (see
during the setup wizard, you can go back and change them by typing the number
corresponding to the item you want to change at the command prompt.
16 At the Command prompt, type
and restart the SKM key server. This process takes a few seconds.
Note: You MUST quit at this point. Otherwise your changes will not be saved and
you will not be able to continue the installation process.
17 Complete steps 1-16 on the secondary SKM node before proceeding.
18 When you are finished, do one of the following:
• For pre-SKM 2.4 (240Q) systems, proceed to
SKM Server for Pre-SKM 2.4 (240Q)
• For SKM 2.4 (240Q) and later systems, proceed to
the SKM Server for SKM 2.4 (240Q) or Later
19
Figure 8). If you made any mistakes
and press <Enter> to quit, save your changes,
q
Installing TLS Certificates on the
on page 25.
Installing TLS Certificates on
on page 28.
Installing and Configuring the SKM KVM Servers