Quantum Scalar i40 Quick Start Manual page 16

Quantum Scalar Key Manager 2.5 Quick Start Guide
Figure 8 SKM Admin
Commands
16
20 At the Command prompt, type
and restart the SKM key server. This process takes a few seconds.
Note: You MUST quit at this point. Otherwise your changes will not be saved and
you will not be able to continue the installation process.
21 Complete steps 1-20 on the secondary SKM node before proceeding.
22 When you are finished, do one of the following:
• For pre-SKM 2.4 (240Q) systems, proceed to
SKM Server for Pre-SKM 2.4 (240Q)
• For SKM 2.4 (240Q) and later systems, proceed to
the SKM Server for SKM 2.4 (240Q) or Later
Caution: Do NOT power on the VM instance yet. Wait until you configure the
MAC ID per the instructions below. Otherwise, you will have problems
with the MAC address later.
and press <Enter> to quit, save your changes,
q
Installing TLS Certificates on the
on page 25.
Installing TLS Certificates on
on page 28.
Installing and Configuring the SKM VMware Servers