Antenna Stabilization - Garmin G1000 Reference Manual

ground mapping
1) Select the MODE Softkey.
2) Select the GROUND Softkey to place the radar in Ground Map Mode.
3) Select the BACK Softkey.
sector scan
1) While in the Horizontal Scan Mode, move the Joystick right or left to place
the Bearing Line in the desired position. The location of the Bearing Line
will become the center point of the Sector Scan.
2) Press the FMS Knob to display the cursor.
3) Turn the large FMS Knob to place the cursor in the SECTOR SCAN field.
4) Turn the small FMS Knob to select FULL, 60˚, 40˚, or 20˚ scan.
5) If desired, readjust the Bearing Line with the Joystick to change the center
of the Sector Scan.
6) Press the FMS Knob to remove the cursor.

Antenna stabilization

1) To activate or deactivate the antenna stabilization, select the MODE
Softkey.
2) Select the STAB ON Softkey to activate antenna stabilization or select
the STAB OFF Softkey to deactivate. The current stabilization condition is
shown in the upper right of the weather radar display.
Weather Attenuated Color highlight (WAtCh
To activate or deactivate the WATCh
feature is only available in the horizontal Scan Mode.
Weather Alert
To activate or deactivate Weather Alert, select the WX ALRT Softkey. Activating
and deactivating will also enable or inhibit the alert on the PFD.
Automatic standby
When the weather radar system is in the Weather or Ground Map Mode, upon
landing the system will automatically switch to Standby Mode.
190-00600-02 Rev. A Garmin G1000 Cockpit Reference Guide for the Cessna Citation Mustang
)
®
® feature, select the WATCH Softkey. This
hazard Avoidance
41