Table of Contents
Advertisement
In this dialog box, you can manually set the LCD and hard drive's time-out values in the Plugged in column and in the
Running on batteries column. Lower time-out values will save more battery power.
Note: Also consult Windows user guide for more information on how to use Windows power
management functions.
Note: Actual dialogue box shown above may appear slightly different.
Suspend Mode
Standby Suspend
The system automatically enters this mode after a period of inactivity, which is set in the Power Schemes dialog box. In
Standby mode, hardware devices, such as display panel and hard disk, are turned off to conserve energy.
Hibernate Suspend
In this mode, all system data are saved in the hard disk before powering down. When this mode is activated, all system
state and contents are saved to the hard disk drive after a period of inactivity defined by the user. No power or very little
power is drawn from the battery module under this mode. However, depending on how much RAM that have been
installed on your computer, the amount of time the system requires to restore all its previous contents can range from
5 to 20 seconds. For Windows 2000 / XP users, hibernation is handled by the operating system; therefore, no special disk
partition or disk file is necessary. If you wish to activate Hibernate mode, you need enable Hibernate Support in the
Hibernate tab of the Power Options menu.
18
PRESTIGIO VISCONTE 1300
Advertisement
Table of Contents
