Wired Remote Controller - Fujitsu AB*A30LBT Service Instruction

8-5-5 WIRED REMOTE CONTROLLER

1
2
3
DIP SW
4
5
6
SWITCH POSITION
Wired remote controller
Front case (back side)
Do not use
this DIP Switch 2
1. SW setting
1-1 Dual remote controller setting
Set the remote controller DIP switch 1 No.2 according to the following table.
Number of
remote
controller
1 (Normal)
2 (Dual)
1-2 Memory backup setting
Set to ON to use batteries for the memory backup.if batteries are not used,
all of the settings stored in memory will be deleted if there is a power failure.
This function is wired remotecontroll only.
DIP-SW
No.6
OFF
ON
Wired remote controller
Can be used. ( Do not change.)
Dual remote controller setting
Filter reset operation and filter display
( Duct model is nonfunctional.)
Can be used. ( Do not change.)
Can be used. ( Do not change.)
Memory backup setting
OFF
1
2
3
4
5
6
DIP Switch 1
( Factory setting)
Master unit Slave unit
DIP-SW 1 DIP-SW 1
No.2 No.2
OFF
OFF
ON
( Factory setting)
Memory backup
Invalidity
Validity
08-11
ON
ON