Gardeo GSEBRTHE18VLI Original Instructions Manual page 55

Nevertheless, some kickback can not be avoided when cutting with the upper tip of the blade. Be prepared
for some kickback when using this area of the blade or hitting another branch with this area. Always hold the
unit firmly in both hands.
Thin branches can be cut off with one single cut. To prevent the branch from slivering and buckling the
branch should be cut off in several pieces.
When cutting off lager branches, you should first cut into the branch form below. First cut into the branch
from below outside the place where you intend to cut off the branch. The cut should go from one third to
halfway through the branch. This prevents the branch from buckling when you cut into the branch from the top
outside the first cut. Last cut off the stump with one clean cut. You might want to seal the cut with a suitable
compound.
Lubrication
After each use, clean the blades and lightly lubricate with general purpose oil or spray lubricant.
K.CONVERTING FROM the Chain saw to hedge trimmer.
The following steps can tell you how to convert from the chain saw to the hedge trimmer:
WARNING:
Never attach or adjust any attachments while power head is running.
Release the trigger and allow the prunner to get a stop ,and unplug the chain saw
loosen the screw by turning it counterclockwise。 。 。 。
rotating the cutting head and remove it, and bring the hedger trimmer head.
Page 55 de 65