Gardeo GSEBRTHE18VLI Original Instructions Manual page 54

Chain Tension
turning it
counter-clockwise slackens the chain. Beware of the sharp edges of the sawchain.
Assemble the cutting head to the unit.
The cutting head is supplied lonely, you mustassemble it correctly before you use the unit。
1> remove the plug from the power supplier,and release the trigger。
2> Align the cutting head to the support housing(1) and then rotate it by clockwise until it is locked。
3> Aligh the hole in the support housing(7) with the screw on the cutting head。
4> Tightten the screw securely by screwdriver。
Cutting tips for chain saw.
Do not work with an angle higher than 60°. The pole saw will work under higher degrees, but there is the
danger of being injured by branchesfalling without warning.
Keep an eye at the ground while working to avoid tripping over fallen branches.
Never use the pole saw without oil, use bio-degradable chainsaw oil.
To operate the Prunner push forward the Safety switch and then pull the switch.
The Prunner is equipped with a low-kickbach chain and it was also done everything from an engineering
point of view to keep kickback low.
Page 54 de 65
Oil Duct
Chain Tensioner
The chain should not be too loose, but
you should be able to lift it off the guidebar a
few millimetres. Use the chain tensioner to
tension the chain.
Always pull the power plug before
undertaking any maintenance work.The allen
head screw of the chain tensioner is at the
front of the pole saw'shear next to the guide
bar. Turning it clockwise tightens the chain,