Features Menu Settings; Active Antenna; Off Time - Tele System PALCO 22/L03 User Manual

7.3-Features Menu Settings

Press the MENU button on your remote
control. Select FEATURES tab by pressing
the Up/Down movement buttons and press
the OK button. The Features menu will be
displayed. You can select the titles for which
you would like to perform an operation in
this menu by using the Up/Down movement
buttons.
FEATURES
LANGUAGE

OFF TIME

PANEL LOCK
DIGITAL FEATURES
RESET

ACTIVE ANTENNA

DECODER
CHANGE
Note: The DIGITAL FEATURES tab in
the features menu is deactivated in Analog
mode. It is activated in Digital mode only.
7.3.1-Language
Select the Language tab and press Right/
Left movement buttons to select the
language of the desired country. All the
setting displays of your television will be
shown in the language that you selected.
7.3.2-Off Time
Off Timer switches your television
automatically to Standby Mode after the
preset time has elapsed. You can adjust
this time between 15 and 120 minutes with
increments of 15 minutes. To activate this
feature, select the Off Time tab and press
Right/Left movement buttons to select the
desired time.
7.3.3-Digital Features
You can adjust the Digital TV features from
this menu. See page 12.
ENGLISH
OFF
OFF
OFF
OFF
BACK
19 I
7.3.4-Reset
You can restore the factory settings of your
television with this feature. To do this, select
RESET tab and confirm with OK button.
Your television will return to factory settings.
7.3.5-Active Antenna
When this feature is set to On, you can feed
an external antenna you will connect to your
television by the tuner of your television
without needing any external source. Active
Antenna output power is -5V / 50 mA.
Note: Digital Features option under the
Features menu is only active in Digital mode.
This option cannot be accessed in Analog
mode.
7.3.6-Decoder
This feature is used to turn off the sound
and picture output on the scart. If the
scart output is required to be active (on)
for an analog decoder or recorder device
that will be connected via its socket, then
switch to the channel to be recorder and
set the DECODER option to ON from the
FEATURES menu by means of right/left
movement buttons. This value should be
stored separately for each channel.
EN