Performing The Initial Power-On Settings; Tv Controls; Main Menu - Tele System PALCO 22/L03 User Manual

6

Performing the initial power-on settings

6.1-TV controls

6.1.1-Temporary on/off (STAND-BY)
When you press the red STAND-BY
button located on the upper right hand
side of your remote control while your
television is switched on, the sound
and the picture will go off. In the
stand-by mode, the power indicator
of your television will glow brighter. To switch
your television back on, either press any
numeric button or PR+/PR- buttons.
Caution! If you are not going to use your
television for a long time, unplug its power
cable from the socket.
6.1.2-Program selection
You may switch to the previous or
next program by pressing the P-/
P+ buttons located on your television
and your remote control. You may
enter the number of the program
you would like to select using the
numerical buttons. For example, to
switch to the program number 12,
press respectively the numeric buttons
1 and 2 on your remote control. You
can perform the program selection also from
the Program Table. Please see page 11 for
Digital Program table and page 15 for Analog
Program table.
6.1.3-Digital TV, Analog TV and AV
Mode Selection
Press the AV button on your remote
control. SOURCE menu will be
displayed. Select DIGITAL, ANALOG
or desired AV mode with Up/Down
movement buttons and confirm with
OK button so that your television
will switch to the source you have
selected.
6.1.4-Temporary sound mute (MUTE)
To temporarily mute the sound of
your television, press the MUTE
button on your remote control. In
that case, MUTE symbol will appear
on the screen. When you press the
same button a second time, the sound will
be restored. If you press the VOL+ button
while in the Mute mode, the sound level is
increased and the Mute function is aborted.
6.1.5-Returning to Selected Program
(SWAP)
Allows you to switch between the
current program you watch and the
last selected program. For example, if
you change the channel to Program 11 while
you were watching Program 1, press SWAP
button to switch back to Program 1. Press
SWAP button to switch back to Program 11
again.

6.1.6-Main Menu

Press the MENU button. The Menu including
all the setting menus will appear on the
screen. Navigate through the Menu titles
with the Up / Down movement buttons and
press the OK button to select the desired
menu. If you want to exit the menu in any
step, or return to the previous menu while
you are in a sub menu, just press the MENU
button.
MAIN MENU
SOUND
PICTURE
PROGRAM TABLE
SETUP
FEATURES
SELECT
9 I
EN
EXIT