Danfoss VLT 2010 Manual page 13

Operation
Operational Modes
Display Mode
Shows value and unit —
Status, and source of control —
Menu Mode
Parameter number flashes —
Parameter Mode
Flashing parameter numbe —
Data Mode
NOTE: To store the newly selected data value,
you must quit Data group, by pressing "Menu".
Alarm Mode
NOTE: If TRIP is displayed the operation has
stopped and you must press the "Reset" key to
reset the VLT.
14
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Defines the display —
0.. = Cursor flashes
0 = Cursor flashes —
Selected data value —
E = Cursor flashes —
Selected data value
Reset mode —
Cause of alarm —
15.0 Hz
FREQUENCY
RUN OK LOCAL. 1
0.0 Hz
0 . .OPERATION
AND0DISPLAY 0000
0.0 Hz
0000LANGUAGE0000
ENGLISH000000001
0.0 Hz
LANGUAGE0ENGLISH
ENGLISH000000001
ALARM
TRIP000000000000
MOTOR TRIP000000
®
VLT Series 2000
— Direction of rotation
— Setup number
— Parameter group
— Name
— Parameter name
— setup number
— Parameter name
— Setup number
NOTE: If TRIP LOCKED is
dispalyed you must switch off the
VLT and switch it on again. Press
the "Reset" key to reset the VLT.