Table of Contents
Advertisement
Super X11QPH+ User's Manual
Unit Identifier Switch/UID LED Indicator
A Unit Identifier (UID) switch (UID) and a rear UID LED Indicator (LED1) are located on the
I/O back panel. When you press the UID switch, the UID LED indicator will be turned on.
Press the UID switch again to turn off the LED. The UID Indicator provides easy identification
of a system unit that may be in need of service.
Note: UID can also be triggered via IPMI on the motherboard. For more information
on IPMI, please refer to the IPMI User's Guide posted on our website at http://www.
supermicro.com.
IPMI_LAN Port
An IPMI-dedicated LAN that supports GbE LAN is located next to USB 2/3 ports on
the backplane. The IPMI_LAN is supported by the Aspeed AST2500 BMC (Baseboard
Management Controller). This port accept a RJ45 type cable. Please refer to the LED Indicator
Section for IPMI_LAN LED information.
2 1
VGA
UID
BMC
J19
JPCIE1
J18
BMC_HB
_LED1
CPLD
JBT1
PCH
SXB2
J20
CPU2
JF1
BIOS
LICENSE
CPU3
J26
FAN6
FAN5
UID Switch
Pin Definitions
Pin#
Definition
1
Ground
2
Ground
3
Button In
4
Button In
COM1
IPMI_LAN
USB 2/3(3.0)
JUSB3
J21
BIOS
JSTBY1
I-SATA4~7
JUSB1
J22
JBAT1
S-SATA0~3
I-SATA0~3
PSU2
J25
CPU1
IPMI CODE
X X
X11QPH+
REV.1.01
BAR CODE
CPU4
UID LED
Pin Definitions
Color
Status
Blue: On
Unit Identified
1. UID
2. UID LED (on the motherboard)
3. IPMI LAN
PSU1
J24
J29
3
J30
42
1
Advertisement
Table of Contents
