Table of Contents
Advertisement
Motherboard Features
CPU
•
Quad Intel Xeon 81xx/61xx/51xx series processors (P0); each processor supports Intel® UltaPath Interconnect (UPI) of
up to 10.4 GT/s
Note: All CPUs need to be installed for full access to the PCI-E slots, DIMM slots, and onboard controllers. Refer
to the block diagram on page 18 to determine which slots or devices may be affected.
Memory
•
Integrated memory controller supports up to 6TB of DDR4 3DS LRDIMM/LRDIMM/RDIMM ECC (288-pin) 2666/2400/2133
MHz modules in 48 slots
DIMM Size
•
Up to 128 GB at 1.2V
Note 1: Memory speed support depends on the processors used in the system.
Note 2: For the latest CPU/memory updates, please refer to our website at http://www.supermicro.com/products/
motherboard.
Chipset
•
Intel C621 PCH
Expansion Slots
WIO 2x16 (PCI-E 3.0) slot (for CPU2 Port1/ CPU2 Port2) (J18/J19/J20)
WIO x8 (PCI-E 3.0) slot (for CPU2 Port3)
Ultra IO x40 slot (for CPU1 Port3/CPU1 Port1/CPU1 Port2) (J21/J22/J23)
PCI-E 3.0 riser card slot with support of 56 lanes (for CPU2 Port3/CPU3 Port2/CPU3 Port3/ CPU3 Port1) (J26/J27)
PCI-E 3.0 riser card slot with support of 48 lanes (for CPU4 Port1/CPU4 Port3/CPU4 Port2) (J29/J30)
Network
•
One (1) IPMI_dedicated_LAN located on the rear IO backpanel
BaseBoard Management Controller (BMC)
•
ASpeed AST 2500 (A2) Baseboard Controller (BMC) supports IPMI 2.0
Graphics
•
Graphics controller via ASpeed AST 2500 (A2) BMC
I/O Devices
•
Serial (COM) Port
•
SATA 3.0
•
RAID (PCH)
Motherboard Features
•
One (1) Fast UART 16550 port on the I/O back panel
•
Eight (8) SATA 3.0 ports supported by Intel PCH (I-SATA 0-3, 4-7)
•
Four (4) S-SATA 3.0 connections (S-SATA 0-3) supported by Intel SCU
•
Two (4) S-SATA 3.0 with power-pins built with support of SuperDOM devices
(S-SATA4/S-SATA5)
•
RAID 0, 1, 5, 10
15
Chapter 1: Introduction
Advertisement
Table of Contents
