Replacing The Cutter Or Control Unit - AAD Vigil Cuatro User Manual

7.2. Replacing the Cutter or Control Unit

We highly recommend that replacements of a Cutter or Control Unit from the VIGIL

a certified rigger or through a VIGIL
Replacing the Cutter Unit after activation, or the Control Unit if necessary, is a simple and fast
process which can be performed quite easily by your rigger or through a Vigil
Every (dis)assembling operation must be done with the VIGIL
How to be sure the Vigil
32 1. Press on the push button only one single time to display "Cuatro" on screen.
2. Wait until a blank screen appears again (proves that the unit is switched off).
3. Perform procedure as shown and described on page 33.
4. Perform a new start up procedure for final check. (see page 15 § 3.5.2.)
5. Fill in the Service Card (see pages 34 & 35 § 7.3.)
® dealer.
Cuatro is switched off.
®
Cuatro be done by
®
dealer.
®
Cuatro switched off. (see page 23 § 3.5.9.)
®