Choice Confirmation - AAD Vigil Cuatro User Manual

For example:
Action
1. Wait
2. Push
3. Push
4. Push
All of the parameter sequences are described in the Parameter Sequence Flow Chart. (see page 43 § 12.)

3.5.8. Choice confirmation

The green LED flashes five times and the message «
22
Vigil Cuatro is ready for use.
®
Remark: While the message «

(INFO, SETUP or CONFIG) for a possible verification or modification.
If no altitude correction is entered, the chosen («PRO», «STUDENT », «TANDEM» or «XTREME») mode remains
displayed. If an altitude correction was entered, the chosen mode will be displayed as "P" (for PRO), "S" (for STUDENT),
"T" (for TANDEM) or "X" (for XTREME) followed by a «+» or «-» sign preceding the value of the implemented altitude
correction (see example page 20). The value will be shown in feet (ft) or meters (m).
BEFORE EACH JUMP, check the unit carefully for any implemented mode or altitude correction (in ft. or m).

After switch on, the Vigil
(see page 25 for more detail).
At the next switch-on, Vigil
the ground zero reference. The ground zero reference is recalibrated at each switch on.
Display
«CONFIG» displayed
Choose between «Feet» or «Meters»
Choose between «U.S. » or «Metric»
(°Fahrenheit, mph, inches of mercury or °Celsius, km/h, hectoPascal)
Choose between normal or reversed display «View» or
Enjoy» is displayed, by pushing the button you can go back to the three menu's
Cuatro stays on for a period of 14 hours, and will then switch off automatically
®
Cuatro will remember and keep all of the previous settings used with the exception of
®
Enjoy» is displayed for a few seconds to confirm the