Starting Up The Vigil® Cuatro; Self Tests - AAD Vigil Cuatro User Manual

3.5.2. Starting Up the Vigil® Cuatro
The Vigil Cuatro becomes operational after pressing the orange push button four times.
®
These short presses must be done immediately after each flash of the red LED. After the first push (hold for 1 or
2 seconds) the «Cuatro» message is shown. If no message appears, please repeat the previous operation.
«Cuatro» is immediately followed by «Vigil» on the LCD.
Press the push button immediately after the red LED first flashes.
Press the push button immediately after the second flash of the red LED.
Press the push button immediately after the third flash of the red LED.
The Vigil Cuatro will then automatically start its self-test sequence.
®
In short:
Action Result
«Cuatro» followed by «Vigil» appears + flash ➯ (2)
1. Push
2. Push Flash ➯ (3)
3. Push Flash ➯ (4)
4. Push Start of self tests
The startup and shut down procedures listed in this manual have been established to reduce the risk of an
unwanted start up or shut down sequence and to ensure that the Vigil
accidentally pressing the push button.

3.5.3. Self Tests

The Vigil Cuatro automatically goes through a complete test sequence each time it is switched on.
®
It verifies that the battery pack, the cutter and the electronic circuits (main functions) are in proper working order.
« VIGIL»
« VIGIL»
« VIGIL»
« BAT OK »
Cuatro cannot be turned on or off by
®
15