Communication Status; Operation Using Process Data - WEG SCA06 User Manual

3. For the master configuration, you must indicate the number of I/O words exchanged with the master. It is
necessary to select word by word, first selecting all input words and then all output words.
4. The PROFINET module is recognized as "SCA06", at the "General" category. Using these settings you can
program the network master to communicate with the equipment.
9.6.4

Communication Status

Once you install the network and program the master, you can use the LEDs and equipment parameters to identify
some states related to communication.
The LEDs "NS" and "Link" provide information about the state of the interface and communication.
The parameter P0801 indicates the status of communication between the device and the network master.
The network master must also provide information about the communication with slave.
9.6.5

Operation Using Process Data

Once the communication is established, the data mapped in the I/O area is automatically updated between master
and slave. Among the main parameters that can be used to control the device, we can mention:
Status Word
Motor Speed
Torque Current
Present Control Mode
Control Word
Speed Reference
Torque Reference
Control Mode
It is important to know these parameters to program the master as desired for the application.
PROFINET
SCA06 | 33