Verifying The Vpc Configuration - Cisco Nexus 5000 Series Configuration Manual

Verifying the vPC Configuration

DETAILED STEPS
Command or Action
Step 1
switch# configure terminal
Step 2
switch(config)# vpc domain domain-id
Step 3
switch(config-vpc-domain)# role priority
priority
Step 4 switch# show vpc brief
Step 5 switch# copy running-config
startup-config
This example shows how to configure a vPC peer link:
switch# configure terminal
switch(config)# vpc domain 5
switch(config-if)# role priority 4000
Verifying the vPC Configuration
Use the following commands to display vPC configuration information:
Command
switch# show feature
switch# show port-channel capacity
switch# show running-config vpc
switch# show vpc brief
switch# show vpc consistency-parameters
switch# show vpc peer-keepalive
Cisco Nexus 5000 Series NX-OS Layer 2 Switching Configuration Guide, Release 5.0(3)N1(1)
134
Purpose
Enters configuration mode.
Selects an existing vPC domain on the switch, or creates a new vPC
domain, and enters the vpc-domain configuration mode. There is no
default domain-id ; the range is from 1 to 1000.
Enters the role priority that you want for the vPC system priority. The
range of values is from 1 to 65535. The default value is 32667.
(Optional)
Displays information about each vPC, including information about the
vPC peer link.
(Optional)
Copies the running configuration to the startup configuration.
Purpose
Displays whether vPC is enabled or not.
Displays how many EtherChannels are configured
and how many are still available on the switch.
Displays running configuration information for vPCs.
Displays brief information on the vPCs.
Displays the status of those parameters that must be
consistent across all vPC interfaces.
Displays information on the peer-keepalive messages.
Configuring Virtual Port Channels