Vpc Interactions With Other Features; Vpc And Lacp; Vpc Peer Links And Stp - Cisco Nexus 5000 Series Configuration Manual

vPC Interactions with Other Features

vPC Interactions with Other Features

vPC and LACP

The Link Aggregation Control Protocol (LACP) uses the system MAC address of the vPC domain to form
the LACP Aggregation Group (LAG) ID for the vPC.
You can use LACP on all the vPC EtherChannels, including those channels from the downstream switch. We
recommend that you configure LACP with active mode on the interfaces on each EtherChannel on the vPC
peer switches. This configuration allows you to more easily detect compatibility between switches, unidirectional
links, and multihop connections, and provides dynamic reaction to run-time changes and link failures.
The vPC peer link supports 16 EtherChannel interfaces.
When manually configuring the system priority, you must ensure that you assign the same priority value
Note
on both vPC peer switches. If the vPC peer switches have different system priority values, vPC will not
come up.

vPC Peer Links and STP

When you first bring up the vPC functionality, STP reconverges. STP treats the vPC peer link as a special
link and always includes the vPC peer link in the STP active topology.
We recommend that you set all the vPC peer link interfaces to the STP network port type so that Bridge
Assurance is automatically enabled on all vPC peer links. We also recommend that you do not enable any of
the STP enhancement features on VPC peer links.
You must configure a list of parameters to be identical on the vPC peer switches on both sides of the vPC
peer link.
STP is distributed; that is, the protocol continues running on both vPC peer switches. However, the configuration
on the vPC peer switch elected as the primary switch controls the STP process for the vPC interfaces on the
secondary vPC peer switch.
The primary vPC switch synchronizes the STP state on the vPC secondary peer switch using Cisco Fabric
Services over Ethernet (CFSoE).
The vPC manager performs a proposal/handshake agreement between the vPC peer switches that sets the
primary and secondary switches and coordinates the two switches for STP. The primary vPC peer switch then
controls the STP protocol for vPC interfaces on both the primary and secondary switches.
The Bridge Protocol Data Units (BPDUs) use the MAC address set for the vPC for the STP bridge ID in the
designated bridge ID field. The vPC primary switch sends these BPDUs on the vPC interfaces.
Display the configuration on both sides of the vPC peer link to ensure that the settings are identical. Use
Note
the show spanning-tree command to display information about the vPC.
Cisco Nexus 5000 Series NX-OS Layer 2 Switching Configuration Guide, Release 5.0(3)N1(1)
114
Configuring Virtual Port Channels