Cisco Nexus 5000 Series Nx-Os Layer 2 Switching Configuration Guide, Release 5.0(3)N1(1 - Cisco Nexus 5000 Series Configuration Manual

Nx-os layer 2 switching configuration guide, release 5.0(3)n1(1)
Hide thumbs Also See for Nexus 5000 Series:
Table of Contents

Advertisement

Configuring Ethernet Interfaces
The following example shows how to display the physical Ethernet capabilities:
switch# show interface ethernet 1/1 capabilities
Ethernet1/1
Model:
Type:
Speed:
Duplex:
Trunk encap. type:
Channel:
Broadcast suppression: percentage(0-100)
Flowcontrol:
Rate mode:
QOS scheduling:
CoS rewrite:
ToS rewrite:
SPAN:
UDLD:
Link Debounce:
Link Debounce Time:
MDIX:
FEX Fabric:
The following example shows how to display the physical Ethernet transceiver:
switch# show interface ethernet 1/1 transceiver
Ethernet1/1
sfp is present
name is CISCO-EXCELIGHT
part number is SPP5101SR-C1
revision is A
serial number is ECL120901AV
nominal bitrate is 10300 MBits/sec
Link length supported for 50/125mm fiber is 82 m(s)
Link length supported for 62.5/125mm fiber is 26 m(s)
cisco id is --
cisco extended id number is 4
The following example shows how to display a brief interface status (some of the output has been removed
for brevity):
switch# show interface brief
--------------------------------------------------------------------------------
Ethernet
Interface
--------------------------------------------------------------------------------
Eth1/1
Eth1/2
Eth1/3
Eth1/4
Eth1/5
Eth1/6
Eth1/7
...
The following example shows how to display the link debounce status (some of the output has been removed
for brevity):
switch# show interface debounce
--------------------------------------------------------------------------------
Port
--------------------------------------------------------------------------------
...
Eth1/1
Eth1/2
Eth1/3
...
734510033
10Gbase-(unknown)
1000,10000
full
802.1Q
yes
rx-(off/on),tx-(off/on)
none
rx-(6q1t),tx-(1p6q0t)
no
no
yes
yes
yes
yes
no
yes
VLAN
Type Mode
Status
200
eth
trunk
up
1
eth
trunk
up
300
eth
access down
300
eth
access down
300
eth
access down
20
eth
access down
300
eth
access down
Debounce time
Value(ms)
enable
100
enable
100
enable
100

Cisco Nexus 5000 Series NX-OS Layer 2 Switching Configuration Guide, Release 5.0(3)N1(1)

Displaying Interface Information
Reason
none
none
SFP not inserted
SFP not inserted
Link not connected
Link not connected
SFP not inserted
Speed
Port
Ch #
10G(D) --
10G(D) --
10G(D) --
10G(D) --
1000(D) --
10G(D) --
10G(D) --
41

Advertisement

Table of Contents
loading

Table of Contents