Enabling Vpc Auto-Recovery - Cisco Nexus 5000 Series Configuration Manual

Configuring Virtual Port Channels
Name
-------------
Fex id
STP Port Type
STP Port Guard
STP MST Simulate PVST
mode
Speed
Duplex
Port Mode
Shut Lan
Allowed VLANs

Enabling vPC Auto-Recovery

SUMMARY STEPS
1. switch# configure terminal
2. switch(config)# vpc domain domain-id
3. switch(config-vpc-domain)# auto-recovery reload-delay delay
DETAILED STEPS
Command or Action
Step 1
switch# configure terminal
Step 2
switch(config)# vpc domain domain-id
Step 3 switch(config-vpc-domain)# auto-recovery
reload-delay delay
The following example shows how to enable the auto-recovery feature in vPC domain 10 and set the delay
period for 240 seconds.
switch(config)# vpc domain 10
switch(config-vpc-domain)# auto-recovery reload-delay 240
Warning:
Enables restoring of vPCs in a peer-detached state after reload, will wait for 240 seconds
(by default) to determine if peer is un-reachable
This examples shows how to view the status of the auto-recovery feature in vPC domain 10.
switch(config-vpc-domain)# show running-config vpc
!Command: show running-config vpc
!Time: Tue Dec
version 5.0(2)N2(1)
feature vpc
vpc domain 10
peer-keepalive destination 10.193.51.170
auto-recovery
Legend:
Type 1 : vPC will be suspended in case of mismatch
7 02:38:44 2010
Cisco Nexus 5000 Series NX-OS Layer 2 Switching Configuration Guide, Release 5.0(3)N1(1)
Type Local Value
---- ---------------------- -----------------------
1 20
1 Default
1 None
1 Default
1 on
1 10 Gb/s
1 full
1 fex-fabric
1 No
- 1,3-3967,4048-4093
Purpose
Enters configuration mode.
Enters vpc-domain configuration mode for an existing vPC
domain.
Enables the auto-recovery feature and sets the reload delay
period. The default is disabled.
Enabling vPC Auto-Recovery
Peer Value
20
Default
None
Default
on
10 Gb/s
full
fex-fabric
No
1-3967,4048-4093
123