Removing And Replacing The Rear Housing - Motorola MOTORAZR2 V9 Service Manual

Level 1 and 2 Service Manual

Removing and Replacing the Rear Housing

G
G
6809513A83-O
This product contains static-sensitive devices. Use anti-static handling procedures
to prevent electrostatic discharge (ESD) and component damage.
1. Remove the battery cover, battery, and SIM as described in the procedures.
In addition to 2 screws, the rear housing assembly is fastened with plastic latches.
These are fragile and should be released with care.
2. Using a Torx driver with a T-5 bit, remove the screws at each side of the phone.
Retain the screws for reassembly. See Figure 4.
Figure 4. Removing the Rear Housing Screws
3. Turn the phone over so the keypad is facing upward.
4. Use the disassembly tool to remove the bumper pad below the keypad.
September 12, 2007
Disassembly
Housing Screw
Housing Screw
v477874
19