Disassembly Instructions - Mitsubishi MLZ-KA25VA Service Manual

11

DISASSEMBLY INSTRUCTIONS

<"Terminal with locking mechanism" Detaching points>
The terminal which has the locking mechanism can be detached as shown below.
There are 2 types ( Refer to (1) and (2)) of the terminal with locking mechanism.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.
(1) Slide the sleeve and check if there is a locking lever or not.
Sleeve
Locking lever
MLZ-KA25VA MLZ-KA35VA MLZ-KA50VA
OPERATING PROCEDURE
1. Opening the intake grille
(1) Press the area indicated "PUSH" on the intake grille until a
click is heard (Figure 1).
(2) Hold the tabs on both sides of the intake grille and pull it
down.
2. Removing the intake grille
(1) Press the area indicated "PUSH" on the intake grille until a
click is heard.
Hold the tabs on both sides of the intake grille and pull it
down (Figure 1).
(2) Pull the hinges of the intake grille toward you (Figure 2).
(3) Unhook the safety strings supporting the intake grille from
the front panel (Figure 3).
Figure 1
Figure 2
Figure 3
OBH483D
Slide the sleeve.
Pull the terminal while
pushing the locking
lever.
NOTE: Turn OFF the power supply before disassembly.
Photo 1
Remote
control
receiving
section
Electrical
box
Safety strings
for prevent-
ing the intake
grille from
falling
36
(2) The terminal with this connector has the
locking mechanism.
Hold the sleeve, and
pull out the terminal
slowly.
Connector
PHOTOS
Places for installing the Anti-Allergy Enzyme
, ,
filter ( ,
E1 E2 E3
Silver-ionized air purifier filter (
Places for installing the air filters
(Catechin air filter
Air purifying filter
)/
ER3
, ) (Option)
E4 ER4
Intake grille
, , , /
E1 E2 E3 ER3
, ) (Option)
E4 ER4