Disassembly Instructions - Mitsubishi MXZ-2D33VA Service Manual

DISASSEMBLY INSTRUCTIONS

12
<"Terminal with locking mechanism" Detaching points>
The terminal which has the locking mechanism can be detached as shown below.
There are 2 types ( Refer to (1) and (2)) of the terminal with locking mechanism.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.
(1) Slide the sleeve and check if there is a locking lever or not.
Sleeve
Locking lever
12-1. MXZ-2D33VA
MXZ-2D53VA
OPERATING PROCEDURE
1. Removing the cabinet and the panels
(1) Remove the screws fixing the service panel.
(2) Pull down the service panel and remove it.
(3) Disconnect the power supply and indoor/outdoor connecting wire.
(4) Remove the screws fixing the top panel.
(5) Remove the top panel.
(6) Remove the screws fixing the cabinet.
(7) Remove the cabinet.
(8) Remove the screws fixing the back panel.
(9) Remove the back panel.
Photo 2
Screws of
the cabinet
OBH626L
Slide the sleeve.
Pull the terminal while
pushing the locking
lever.
MXZ-2D40VA MXZ-2D42VA
MXZ-2D53VA2 MXZ-2D53VAH MXZ-2D53VAH2
Screws of the terminal
block support and the
back panel
(2) The terminal with this connector has the
locking mechanism.
Connector
MXZ-2D42VA2
NOTE: Turn OFF the power supply before disassembly.
Photo 1
Photo 3
166
Hold the sleeve, and
pull out the terminal
slowly.
PHOTOS
Screws of
the top panel
Screws of
Service
Hooks
panel
Screws of
the back panel
Direction
to remove