Assembling the Unit
10
9
5
Mounting the Gearbox
:
Loosen the clamp screws (9).
:
Push the gearbox (10) onto the
drive tube (5) – turn the gearbox
back and forth as necessary.
HL-KM
10
9
:
Once the end of the drive tube is
inserted beyond the slot in the
clamp (11), push it fully home as far
as stop.
:
Fit the clamp screws and tighten
down moderately.
:
Line up the gearbox (10).
Tighten down the clamp screws firmly.
Mounting the CombiTool
11
:
:
:
Reverse the above sequence to remove
the drive tube.
English / USA
2
1
4
3
Engage lug (1) on drive tube in
slot (2) in the coupling sleeve and
push home the drive tube as far as
stop.
When correctly installed, the red
line (3) (arrow point) must be flush
with the end of the coupling sleeve.
Tighten the wing screw (4) firmly.
13