Assembling The Unit - Stihl FR 130 T Instruction Manual

English

Assembling the Unit

Mounting the Support Frame
4
3
2
1
Loosen and remove the M 10 x 40
N
screw (1) with lock washer (2) and
plain washer (3) from the
powerhead (4).
Secure the support frame (5) to the
N
powerhead with the screw and
washer (torque down to 20
Nm/177 lbf. in).
14
Installing the Flexible Shaft
5
Remove the protective cap from
N
one end of the shaft.
Push the end of the flexible shaft (1)
N
into the sleeve (2) until it engages –
turn the shaft back and forth at the
same time.
Remove the protective cap from the
N
other end of the shaft.
Push the flexible shaft into the
N
powerhead coupling (3) until it
engages – turn the shaft back and
forth at the same time.
Keep the protective caps in a safe
N
place.
Mounting Loop Handle with Barrier Bar
A barrier bar may have to be mounted to
the loop handle to suit the market and
the cutting attachment you intend to use
– see "Approved Combinations of
Cutting Attachment, Deflector and
Handle".
1
The barrier bar comes standard with the
machine or is available as a special
accessory.
1
2
3
N
1 1
2
2
1 1
Fit the square nuts (1) in the barrier
bar (2) – make sure the holes line
up.
FR 130 T