Card Rack Assembly Removal - NCR PC4i Owner's Manual

OPTIONS INSTALLATION
2. Grasp the card rack at both sides and carefully pull out two to
three inches from the cabinet. (NOTE: The card rack must be
pulled away from the cabinet a few inches to allow clearance for
the cabinet top.)
3. With a screwdriver, remove the two screws in the lower back of
the cabinet (see Figure 3-1).
4. Grasp the cabinet top at both sides, with a slightly outward pull,
slide the top off toward the rear.
5 T,av the cabinet top to the side out of the way.

Card Rack Assembly Removal

1. Make a note of their positions, and disconnect any cables that
may be connected to the exterior of the card rack assembly. (See
Figure 3-8.)
2. Turn the screw-lock that secures the card rack assembly 90
degrees counter-clockwise (see Figure 3-2).
3-2
Figure 3-1 Cabinet Removal
OWNER S MANUAL