Pre-Run Inspections; Water Supply Connections; High Pressure Hose; Vacuum Hose - Prochem LEGEND GT Operating Instructions Manual

PRE-RUN INSPECTION
Operate this unit and equipment only in a well-
ventilated area. Exhaust fumes contain carbon
monoxide which is an odorless and deadly
poison that can cause severe injury or fatality.
DO NOT operate this unit where the exhaust may
enter any building doorway, window, vent, or
opening of any type.
CHECK FOR ADEQUATE FUEL
Check the fuel tank to be certain there is adequate
fuel to complete the job. This unit uses
approximately .75 – 1.00 gallons of fuel per hour,
depending on the speed setting.
REMOVE TOOLS FROM VEHICLE
Remove any tools or hoses from the van which you
will require.
WATER SUPPLY CONNECTION
NOTE: Before connecting your water hose to the
supply faucet, flush out the faucet until the water
is free of any debris. Flush out any debris which
may be in your water inlet hose.
1. Connect the water supply hose to the side
panel water inlet quick-connect on the right
front of the console. Connect the hose to the
water supply faucet.
NOTE: Never use your waste pump outlet hose
as a water inlet hose. Use only clean hoses for
water inlet.
2. Turn the water supply faucet on. The water will
fill the water box.

HIGH PRESSURE HOSE

Before starting the unit, connect the pressure hose
to the outlet connection at the front of the unit.
Connect the cleaning tool to the pressure hose.
WATER UNDER HIGH PRESSURE AT HIGH
TEMPERATURE CAN CAUSE BURNS,
SEVERE PERSONAL INJURY, OR COULD
BE FATAL. SHUT DOWN MACHINE,
ALLOW TO COOL DOWN, AND RELIEVE
SYSTEM OF ALL PRESSURE BEFORE
REMOVING VALVES, CAPS, PLUGS,
FITTINGS, FILTERS AND BOLTS.

VACUUM HOSE

Connect the vacuum hose to the vacuum inlet
connection at the front of the unit. Connect the other
end of the vacuum hose to the cleaning tool.

FILTERS

Ensure all filters on machine and in waste tank are
free of debris.
86313050 LEGEND GT 09/12/08
DANGER
ROTATING
MACHINERY.
WATER UNDER
PRESSURE AT HIGH
TEMPERATURE.
IMPROPER
MODIFICATION OF
EQUIPTMENT CAN
CAUSE SEVERE
PERSONAL INJURY
OR COULD BE
FATAL.
OPERATION
DANGER
DO NOT MODIFY
UNIT WITHOUT
WRITTEN
PERMISSION
FROM
MANUFACTURER
3-11