Table of Contents
Advertisement
U110C-NO FUEL LEVEL BUS MESSAGE —
TEST
4
Turn the ignition off.
Disconnect the PCM harness connectors.
Disconnect the BCM harness connector.
CAUTION: DO NOT PROBE THE PCM HARNESS CONNECTORS. PROBING
THE PCM HARNESS CONNECTORS WILL DAMAGE THE PCM TERMI-
NALS RESULTING IN POOR TERMINAL TO PIN CONNECTION. INSTALL
MILLER SPECIAL TOOL #8815 TO PERFORM DIAGNOSIS.
Measure the resistance of the PCI Bus circuit from the BCM harness connector to the
appropriate terminal of special tool #8815.
Is the resistance below 5.0 ohms?
Yes → Replace BCM in accordance with the Service Information.
→ Repair the PCI Bus circuit between the PCM and the BCM for an
No
ACTION
Perform POWERTRAIN VERIFICATION TEST VER - 1.
open.
Perform POWERTRAIN VERIFICATION TEST VER - 1.
DRIVEABILITY - NGC
Continued
295
APPLICABILITY
All
Advertisement
Table of Contents
